Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi all,Just an advisory that I have had to rollback patch 9 of release 2.4, as API calls with verify=true stopped working. Testing using python 3 on local PC found the error "certificate verify failed: unable to get local issuer certificate".Rolling ...
I am trying to configure ISE to generate and export a report every hour, using the Scheduled Reports tool, but nothing seems to materialise.
I can do a manual one-time export of a report to a saved repository, which runs and appears in the repository...
Hi,
I have a policy rule that to permit access to a device matching a specific device type, which then used a local Identity from the Internal Users DB for authentication.
This was working fine until I enabled Profiling service (RADIUS) on the PSN. ...
Hi Surendra,Yep I can confirm that workaround works. Thank you for the link.I found that if I set the trust certificate to "Trust for client authentication and Syslog" prior to installing patch 9, then the other (new) setting "Trust for certificate b...
The notion of matching group numbers with the VLAN ID is fine until you want to dual-stack your network. You can't use IPv4 and IPv6 addresses in the same HSRP group, so you are probably forced to use common group numbers, covering multiple VLANs, ex...
Well, it seems this is now fixed, again without explanation. Failed over to other admin node and failed back again. Authentication is now working! Go figure.
Thanks for everyone's suggestions, but this seems to be a case of turn it off and on again.
