Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello,I have a Catalyst 1000 switch. I'm having some dropped packets and I'd like to understand why it's happening and see if i can fix the issue.What causes the "Unknown output interface" dropped backets? I read that disabling the information option...
Hello everyone,I am working on setting up DHCP snooping with some Cisco Catalyst 1000 series switches. My main goal is to get this configured correctly so I can also implement Dynamic ARP Inspection and IP Source Guard.Below is a diagram of my networ...
Hello,I'm attempting to access my Cisco Catalyst 1000 switches through OpenVPN. However, the connection just keeps timing out. Am I being blocked locally from the switch? I never added anything on the switch only the route on my OpenVPN confugraiton....
I lost my password and used a method described in here to recover my password How to factory reset a C1000 Switch from boot mode.I interrupted the boot sequence and then executed these commands switch: rename flash:config.text flash:config.text.old ...
Hello Cisco Community,I’m working with a Cisco Catalyst 1000 Series Switch running IOS. I’m trying to enable Administrative Native VLAN Tagging to tag the native VLAN traffic on trunk ports, but the command vlan dot1q tag native isn’t working.Can the...
The errors are on my main distribution switch. I included a diagram below, and the output from the switch. I'm wondering if this is from the APs. Is there anyway to tell what port these errors are coming from? switch#show ip dhcp snooping statistics ...
Okay, thank you. How about the switches DHCP static mappings? That's because the lease negotiation happens solely on the trusted port channel? I don't see those appearing in my table.
Okay, thank you. Any other options or configuration changes you recommend? Also, how do I handle static addresses with the binding table? I have my switches management interfaces set to DHCP and those leases don't seem to populate on the table. I als...
