Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi All, I seem to be having a strange issue with my WLC 5500 and 3500 AP's. It seems that I can only have G clients working or N clients working but not both at the same time.I have WPA2 AES setup and it seems that if I turn on WMM (required or Al...
Hi All, Is there a way on a cisco switch to verify how long its been since Spanning Tree has re-converged, or even to see what *revision* number of STP is running. Essentially I want to see if spanning tree is constantly re-converging and causin...
Hi All,This is a topic which I am having alot of trouble with. Typically to implement qos on a switch I just use the Auto QoS but in this case it does not apply.Lets say we have two switches connected over a WAN 100Mpbs Layer 2 link. I want to provid...
Hi All, This is a topic which I am having alot of trouble with. Typically to implement qos on a switch I just use the Auto QoS but in this case it does not apply.Lets say we have two switches connected over a WAN 100Mpbs Layer 2 link. I want to ...
No. I understand this would be impossible. Picture this:Two wireless clients. Client A has a b/g Card Client B has a b/g/n card.If I disable WMM then only both Client A and Clien B will connect at b/g speeds. Client B will not connect at N like...
