Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi,
I am trying to setup a backup DMVPN tunnel at a spoke site. When I so a sh DMVPN on the hub side I get the following I can ping across tunnel0 but not tunnel1.
Tunnel0, Type:Hub, NHRP Peers:2, # Ent Peer NBMA Addr Peer Tunnel Add State UpDn Tm...
Hi,
I have a 2 spoke to hub DMVPN setup, we are working on getting one spoke setup with 2 ISP's on 2 physical interfaces. I have everything working except the backup tunnel will not connect. I have researched this and followed some examples, but can...
HI I have an ASA 5508-x and have setup the outside interface with the last of the usable IP from my block of 5. I have setup NAT/PAT for different services using the configured address of the outside interface. My problem is that when I try to use a...
HI I need some help. We have a 1811 using a 100mb broadband connection. This is our main connection and we have 2 PTP VPN's (multipoint gre's) on this connection. Recently got a small 20mb fiber connection and we would like to move just our PTP VPN t...
Hi,I am looking for some help with the following:I have a 2 spoke DMVPN scenario. My problems are:•1. If I restart the hub the tunnels don’t come up unless I shut/no shut the tunnels at the spokes•2. When the tunnels come up I am not able to access t...
Can you assign private IP's to your devices and pat the ports over? As mentioned before the gateway and IP's are on the same subnet. You could also do a one to one nat.
Georg,
DO you meant just a new IPsec profile using the same crypto isakmp profile?
ex now there is:
crypto isakmp profile ccp-dmvpn-isakmprofile keyring ccp-dmvpn-keyring match identity address 0.0.0.0
crypto ipsec profile CiscoCP_Profile2 set t...
Georg,
Here the output from sh dmvpn detail, I see that this a shared session and I am guessing that is why when any of the tunnels get shut/no shut they both drop.
What I don't understand is why tunnel0 never comes up unlees I specicically do a shu...
I am back to tunnel1 doesn't connect. I have removed all the changes after the post were you posted config with modifications trying to get back to were tunnels connected. I did remove the neighbor statement from eirgp.
Also if shut down any of the t...
