Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I have searched the internet until my battery died. Can anyone answer how to fix dribbles. If not, why have a counter for them. I have a 4506 one fiber hop away from a 6509 and I am getting dribbles. Please advise...Thanks...
I just don't get it.. I have the following:Cisco 3845 (revision 1.0) with 486400K/37888K bytes of memory.Processor board ID FTX1114A4GW2 Gigabit Ethernet interfaces128 terminal lines1 Virtual Private Network (VPN) ModuleDRAM configuration is 64 bits ...
When I TFTP'd my config to my server, I reviewed it and to my suprise, I did not see any VTP information. Is there another file I need to TFTP to get this information? Does this also mean the I will need to re-enter the VTP information if I replaced ...
I have a habit of installing a new switch into my network and Keep breaking my SC0 setup. Here is what I mean. I configure and install a switch. I set up trunking on the uplink and I can't get to SC0 with it set to VLAN 1. I have to set it to the VLA...
In passing this Access Point from One Engineer to another someone has misplaced the power supply for this access point. Can anyone tell me what pin-out and mW is for this 5VDC input is? Looking into the connection, which is arch shaped, there are thr...
Just to help me totally understand, the 3550 is the only model that you have to ensure that you backup the vlan.dat to ensure you have a complete backup, correct?
