Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I have an IDSM running Sensor version 4.1(4) and Signature S174. It was working perfectly untill few days back . But When telneted in to the IDSM it logs in and logs out instantly showing the error message "Not able to communicate with the Process"....
Dear Friends,I have 2 wan location with 1700 series Router-A and Router-B conencted with Serial connectivity.The LAN Network at Router-A and at Router-B is in same subnet. Eg 150.10.0.0/16 at end A and 150.10.0.0/16 at end B.Now since both side lan s...
I have a FWSM running 2.3(1). i want to limit traffic for certain networks. Can it be done in routed mode? Iwill be thankful for any suggested configs.
How do i enable IP redirection in FWSM ? when I mean traffic coming from one interface nedds to be redirected to some other device in the same interface its not happening in the normal scenario.Is redirection supported in routed mode?
Hi,For monitoring the site to site response , I need to configure rtr on Cisco 3662. But when i give the rtr command, I receive the error "%No memory left to create probes". Memory of the router is 64MB and the IOS is 12.2 which supports rtr.Below a...
The Sensor was working fine for 15 days after the S174 Upgrade and the problem started suddenly. My sensor is IDSM2 which is loaded on a 6509 chasis.There is no external connection except the shutdown button.Packets to be captured are diverted onto t...
Thanks Johansen....I got the answer ..I ment the first one.I wanted to limit the bandwidth usage of a network. In my scenario FWSM is in routed mode and MSFC is doing more of a Layer2 Job... Can bandwidth usage limitation for a network be done on ...
