Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi,I try to configure a Cisco 3925 with VWIC3-1MFT-G703 for an E1 but the line is still downform my side and from the site of the provider the config below:!controller E1 1/0 channel-group 0 unframed!interface Serial1/0:0 ip address XXXX XXXXWhen...
Hi,We ave 2 6509 switchs configured in VSS mode with a FWSM module in each switch. We have also a licences of 20 contexts for each FWSM module.I've read that in the release software 4.0(4) of the FWSM, the integration and deployment of FWSM in a VSS ...
Hi,Thank you for your reply.the line is pluged in a converter and from a converter to a 1700 router. Now we want to change the 1700 router with a 3925 with VWIC3-1MFT-G703 card.The config seems to be correct. I dont find another issue!!If you have an...
Hi,Many thanks for your reply.whant I want to know is in a configuration point of view:do we need to configure HA Active/Active and Active/Passive like if we had 2 separate ASA??? or when we have a 6500 VSS and release software 4.0(4) of the FWSM the...
Hello,Thank you for your reply,yes, the IP@ of the ACS Server is 10.10.40.10.And I think that the ASA is configured to send accounting packets to the ACS. see bellow:aaa-server ACS_ACCOUNTING protocol radiusaaa-server ACS_ACCOUNTING host 10.10.40.10 ...
