Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I am distributing static routes into eigrp.at two sites. Specifically, we are using NSX and SRM so that certain VMs have the same IP address at each site, Main and Backup. At Main, I have two sets of IP addresses with a default route to each subnet...
On CBS350, I cannot delete old images files from the flash via Web interface nor via the CLI. Therefore when I try to upload a new image file it runs out of space.. Please advise.
Or would adding the higher weighted routes to the main site also have the same effect? Once the main site comes back on line eigrp would noticed that the 39.5 route has a higher weighting and the 29.5 route would again take precedence. Just wonderi...
To continue this discussion to its conclusion, I would add the route map configuration to the backup router only just as I did the higher weighted routes, or to both main and backup router. This would be the configuration.
route-map STATIC_TO_EIGRP ...
A continuation on this configuration. The weighted configuration worked just fine. But when the primary site came back up the original routes did not take precedence; the injected routes remained in the routing table. Usually the eigrp routing reco...
