Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi, I recently set up a Cisco ISE 2.4 install for my company. We are using Cisco Anyconnect 4.7 (with NAM component) on WIndows10.PEAP(EAP-MSCHAPv2) and EAP-TLS are working well but if I try to use EAP-FAST(EAP-MSCHAPv2) it fails. I tried with User A...
Hi,I am trying to use a Cisco DMP 4310 with a standard power injector (PRJ3) but it seems that the DMP doesn't start. I tried using the power injector with a phone and also with a wireless access point, it is working.I also tried to plug the DMP to a...
Mike, Here is my authentication policy: The allowed protocols profile is pretty simple too: I tried with Fast-Reconnect enabled but the issue remains the same.My final goal is to use Eap-Chaining but since user authentication is failing using EAP-Fa...
Hi Mike, I used the NAM profile editor and made this configuration, I use PACs: The EAP-FAST configuration is the following (I enabled "pac-less resume" but I do not think I need it): The logs from the NAD are not very handy, here is the switch ou...
Hi,It seems that the Power Injector delivers enought power but I will try with a PoE+ power injector. In the power injector's datasheet there is nothing about a 802.3af (standard for PoE) compliance so I will try with a compliant power injector. I wi...
