I am new to Calllmanger.I have a call manager 5.x. I have a new site turn up. I am going to create region, partition and ccs, then I will use bulk admin tool to create phone and user. All my call mangaer servers have auto registration turn off. How c...
We are runing PIX 535 with software version 8.02. In ASDM, I see anti-spoofing is diable in all interfaces. If I enable it, is there any negative effect? Can I enable it in DMZ, inside, and outside interfaces?Thanks
I need to migrate users from VPN concentrator to ASA. I found one of the user group password has a space character in the concentrator, when I try to put the same password to the ASA, it doesn't allow me to use space . If I create a new group passwor...
We have about 20 servers with dual NICs, we want to run NIC teaming with port channel enable, so we need to create 20 port-channel interfaces. I want to know will this cause a performance issue in a 6509 switch with sup-720?
we have 3 PRIs, al connect to the same gateway(3825). We need to set up the next incoming or outgoing call will go the 2nd PRI if the first one is full. Should we configure that in CallManager, if so, how to do that? or we just need to call the Telco...
So if I have about 30 phones need to add to the new location, I think I'd better insert phone one by one after I import the "user+phone" cvs file in bulk administration?Thanks
I did not know about VSS until you mentioned. I think it is too much for us to implement that now. We will get the NIC redundancy only this time. But could answer my question, I have about 20 LACP in one 6500, is this no problem, or too many, I just ...
I enabled jumbo frame in every port, it hows mtu 9216 in every port. But when I showed vlan, I saw the vlan mtu is still 1500. Do I also need to change the Vlan MTU, or the vlan mtu has no actual effect.Thanks