More specifically, I have a few sites that have full clear channel T1's that will be upgraded to bonded multilink T1's. I have typically done this with (2) WIC-1DSUT1 cards. Instead of using 2 cards in the new ones can I use a VWIC2-2MFT-T1/E1? I ...
We have 2 T1's to different ISP's. We use EIGRP to do outbound load balancing. This is done 1 hop internal to the ISP routers. This works great outbound, but obviously does not work inbound. It hasn't been a problem until recently and now most of...
We have a simple topology, but wish to impliment zoning. I have the zones created, but have not yet activated them. Can I activated them without scheduling a maintenance window? Does data flow stop temporarily while zones are activated?Thanks
We are trying to apply QoS/traffic shapping on out 6500 with FlexWan. The problem occurs when trying to apply the "frame-relay traffic-shaping" to the serial interface the IOS will not take the command. All of the documentation states that this mus...
At one of my sites, we set up a 501 with a DSL connection for guests to use to get internet access and VPN back to their office. Currently we have a pool of 5 static addresses. The global command on the outside implies the pool of IP's to be used. ...
Do you have the tacas server set up and responding? I don't see anything in the config displaying the Tacacs server information.As soon as you paste the config in, you can no longer enter commands without the tacacs server permitting you to do so.
Are the hot brick being NAT'd to a public address, or do the outside interfaces have actuall public IP addresses. Also if there is NAT'ing, are the VPN clients being NAT'd to the same public IP
Have you applied the following command?same-security-traffic permit intra-interfacehttp://www.cisco.com/en/US/products/hw/vpndevc/ps2030/products_configuration_example09186a00805734ae.shtml