Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I have a pre-8.3 firewall configuration I am converting to 8.4. The original configuration had "nat 0" covering all packets that traversed it.Can I just assign routes and acls to this configuration and expect that the traffic will traverse the ASA o...
Hi,I have a customer who would like to change the mode their WCS software uses from application to service mode. Is this possible? Will this require a backup and then reinstall? Any help is appreciated.- Josh
Hello,It is common in the medium buisness to use a large chassis switch (or a pair of them) for both Layer 3 inter-VLAN routing and also Layer 2 port aggregation. For example, a 6513 with 200 hundered triple-speed ports for servers and desktops and ...
I just upgraded my CCA OOB deployment to 4.0.0 and now the linkup/linkdown/MAC address traps are not being received properly. I have connectivity between the switches and the CAM and I sniffed the traps from the switches and they contain all the cor...
All,I have a customer with a PIX515 with a DMZ interface, and I set up the 4215 IPS 5.0(5) to be inline between the PIX and the DMZ switch and between the PIX and the internal switch.In this configuration, traffic that traverses only one of the two i...
And by internal_subnets do you mean 0.0.0.0/0? If I only list the actual subnets in the 3750x area, the customer will not be able to reach the Internet.
Thank you Varun,Here is what I am doing:Customer -> ASA 5520 -> 3750X -> PIX -> InternetI am protecting the "3750X" portion of the network from the Customer network. The customer uses the Internet through the PIX. There cannot be any NAT at...
