Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
The Cisco APIC Installation and ACI Upgrade and Downgrade Guide recommends using a long-lived version 5.2(x) or 4.2(x). However the APIC-M4 doesn't support either - “The Cisco APIC L4/M4 requires the Cisco APIC software 5.3(1) release or later or the...
I have two (new) 9706 with a trunk (multi-VSAN) link between them. Nothing else is connected so all VSANs are inactive.
My question is, would you expect the trunk link to be up or inactive? It is inactive.
Thanks in advance.
In ISE 2.1 Patch 3 I've created an NMAP scan to include customer ports (tcp 8000, 4767 and 8194) and the NMAP Extensions dictionary is updated, but the attribute names do not appear in the profiling conditions pull-down, so i cannot create the condit...
ISE v1.1.0.665, 3395 h/w.Single Admin/Monitor/Policy node.WS-C3560-48TS 12.2(55)SE5 C3560-IPBASEK9-MFor Client Provisioning I created an authorisation policy as follows:download acl "ACL-POSTURE-REMEDIATION"apply url redirect "ACL-POST...
Is DCNM v5.2(2a) compatible with Nexus 1000v v4.2(1)SV1(4a)?We are getting an SNMP OID error when we try.The compatibility matrix (http://www.cisco.com/en/US/partner/docs/switches/datacenter/sw/5_x/dcnm/matrix/matrix.html) is unclear.
I believe the vlan ID is local to the switch and not carried in the vxlan packet. It is the VNI which is carried. The same VNI could map to a different VLAN ID on each switch. In effecf VKAN IDs are local to each switch.
Also you're unlikely to need ...
Could this error be because you used "any", which means ipv4 or ipv6, rather than "any4" ?"Source and Destination addresses should be of the same IP version."
