Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello,
does the catalyst 6506-E with 15.1(2)SY7 (VS-SUP2T-10G) support only MSTP and Rapid-STP?
When I configure the STP mode I have only two choices:
switch(config)#spanning-tree mode ? mst Multiple spanning tree mode rapid-pvst Per-Vlan rapid span...
Hello to everybody,I have a Cisco ASA with csc-ssm.I need to configure wccp on the asa and I want to use csc-ssm for url filtering.So the question is: "May I perform the url filtering to the client requests using csc-ssm before they get the cache ser...
hello everybody, as in the title I have a doubt about a cisco asa 5540 with an SSM-4GE module.when I issue the "show interface detail | b Internal-Data1/0" command, the output I got is that the interface is in administratively down state.Is it norma...
hi everyone,I think I got a strange behavior on a context of my WS-SVC-FWM-1 (on a Catalyst 6509 running IOS 12.2(18)SXF17a) that is running FWSM Firewall Version 4.1(3).This context sends these log messages every ten minutes:Jul 17 2011 23:31:16: %F...
hi to everyone,my MSFC2 sent this strange log message.%DATACORRUPTION-SP-1-DATAINCONSISTENCY: copy errorThe error message decoder tool says: "NOT FOUND".Had someone of you the same log message??The level is "alert".Thank You very much!!giorgio
Hello to Everyone,
I have the same problem.
I have to make the "Host http-header" filtering on SSL connection to choose the correct serverfarm destination.
Do I need to implement an SSL termination on ACE for making "Host http-header" filtering?
th...
About tris Cisco said:Router ID is chosen as the highest IP address configured on the ASA. If that happens to the DMZ interface or the outside interface IP address, then the WCCP server has to have a route to get to that Router-ID address pointing t...
