Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello, Looking for a recommendation for hardware in a high density warehouse environment with 50 foot ceilings. We have the CW9176D1 and the CW9176I models in mind particularly, but the one question/concern I have is for an environment with 50ft ceil...
SpoilerHello all, hoping to get some help in one of my configurations. So my topology is we have a inside network PLC on a 192.168.1.50 address. This address is local only so that the PLC can communicate with its other accessory devices on the 192.16...
Hello all, hoping to get some help in one of my configurations. So my topology is we have a inside network PLC on a 192.168.1.50 address. This address is local only so that the PLC can communicate with its other accessory devices on the 192.168.1.x n...
I was looking a bit on where to go for an issue we had with the latest 17.2.1 firmware update. After the update to our network was complete. Not all POE devices, but specifically axis cameras would intermittently just stop transmitting data across t...
Hello, Our smartnet renewal date passed recently this month. We want to renew our smartnet coverage but we don't know what devices we previously had covered. I wanted to access the smartnet portal to review any devices that were covered but I receive...
Hello, I watched part 1 and part 2 of the video series and modified my own config to mirror the IE switch as L3 Gateway for HMI (routed access, 1a) model and i still had no luck with getting the PLC the nat properly. Its not visible to the outside ne...
This is what we plan to do from here honestly staged upgrade so we can isolate it. There's no predicting when and where the problem occurs so it's been hard to catch it in the act because we don't know what camera will drop and when.
