Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I am looking for some advice or a best practice guide on how to connect a Dell Equallogic array directly into a pair of 6296 FI's. The ecologic array has 2 10 Gig ports per controller so I am thinking it should be cabled with 1 port to each FI on ea...
I have an ASA that sits at a remote site. Its gi0/0 interface connects to the outside world. Its gi0/1 interface connects to a c2800 which in turn connects to our main office via a point to point link with another c2800 on the other side. I am try...
I have set up a remote access ipsec vpn on an asa 5520. I can connect, and ping internal ip addresses, however I cannot ping back out to the internet, nor can the internal network ping the vpn clients and dns resolution internal or external does n...
I am having trouble getting an asa to redistribute a route via ospf. Here is the ospf config for the asa which should be redistributing the 10.253.46.0 network to the c2800.ASA
router ospf 1
network 10.253.46.0 255.255.255.0 area 0
network 207.188...
I have set up a remote access ipsec vpn on an asa 5520. I can connect, and ping internal ip addresses, however I cannot ping back out to the internet, and dns resolution does not work. Any suggestions on where to start troubleshooting?
I believe this should be the pertinent information you need for the config. Let me know if you need something else.show ip ospf neighborNeighbor ID Pri State Dead Time Address Interface216.58.249.126 1 FULL/BDR ...