Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi all, Need suggestions and guidance.I want to install new APs with Australian standards as per model number: AIR-LAP1142N-N-K9 We are using below process to register any new IP, but this time it does not allow and its not visible in WLC WLANs tab.1...
Hi Solemdoms, What my understanding is - the network command works differently with Eigrp and Ospf than it works on BGP.In BGP route is being advertised by network command.But in Eigrp or OSPF when you apply network command, it enables the respective...
Thanks to all of you for the support provided. The investigation and resolution was as below for this case.1. Logged in to the controller with ssh tried giving below commandsdebug mac addr debug capwap events enabledebug event errors enableshow debug...
Hi leolaohoo, what is the correct or common procedure to add a fresh new AP and get it registered with WLC. Should we do it via commmand line or via GUI. Which is most commonly used. Pl. let us know the correct procedure, if we are doing any mistake....
Hi Najaf, No output is comming after we gave the above two commands. We are now stuck with this problem. Pl. help us out. Most probably tomorrow we may be in a position to provide you all the logs. Please let me know for the troubleshooting steps, wh...
