Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
What are the parameters other than CPU, Memory and Storage that should be monitored on Cisco IPS in order to do capacity planning effectively. Currently IPS4270-20-K9 and ASA5585-SSP-IPS60 are active in the production environment.
What are the parameters other than CPU, Memory and Storage that should be monitored on Stealthwatch in order to do capacity planning effectively. Following are been deployed int the production environment FlowCollector for NetFlow 4000FlowReplicator ...
What are the parameters other than CPU, Memory and Storage that should be monitored on Cisco ISE in order to do capacity planning effectively. Currently ISe 3395 with version 1.4 is active in the production environment in distributed deployment mode.
Hello All,We are planning to turn on policy based routing (PBR) on one of our Cisco ASR 1001, on which average resource utilization is around 50%. I came across document that says flow switching will be disabled on the interface on which PBR is enabl...
HelloI am interested to know how the cisco ISE 1.2 base licences are consumed. As the cisco ise 1.2 user guide "The Base License is consumed whenever an authentication notification is received by Cisco ISE." Based on the above statement i have follow...
HelloGot it tested in lab. Cisco ASR 1001 supports CEF enabled PBR. Even though the flow switching is disabled on the interface after enabling command ip policy route-map, but there is no effect on CEF.Thanks Kumar
thanks for the reply Tarik.As I understand, you mean that a base license is consumed by every radius authentication request and then the license is free to be utilised againAlso would this means if Radius accounting is turned off, then concurrent ses...
Hello Amjad,For External Idenity sources Cisco ISE would use Eth0 as the default and only interface to communicate with them. But in case of exteranl RADIUS proxy request its not bounded to Eth0 interface and rather depends on the route on Cisco ISe....
Hi Ahmed,Did a TCP dump on eth1 interface and I could c the external radius proxy traffic being sent through Eth1 interface of ISE. It will put the complete setup and let you know the final results.ThanksKumar
