Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi,We are facing a curious case here. We have been informed that https://sbsftp.benefitfocus.com/ is not accessible and we thought it is being black listed for whatever reason after we whitelisted the address nothing changed and after running a packe...
Hello,I have few question about SIP trunks in general and wondering if some of these scenarios are possible to execute.We have a customer with branches dispersed all over the place and DR sites.We have two ingress SIP points one in HQ and one in DR. ...
I was implementing a SIP trunk from Verizon for a customer and I was skimming through the document specific for Verzion and CUBE on ISR 4K series and I realized on the CUBE it says early-offer forced but the trunk from CUCM to CUBE has the SIP profil...
Hi,
I was playing around with ASA Site to Site VPN and NAT rules and created this rule for the traffice from DR_172.27.0.0 to go over the IPsec Tunnel to get to the HQ_192.168.0.0
Manual NAT Policies (Section 1)1 (any) to (any) source static DR_1...
Hi,
We have a private multipoint WAN connection between our sites.
Some of the sites have cisco routers on the edge like 3925 and some site have 3750x switches and two sites have nexus 9300 siwtches. All these sites are connected over vlan 254 and ro...
Can you please explain number 11 more? Especially this part: Automatically update the next hop value routes learned on partially meshed networks to the directly connected neighbor Thanks!
You can always use reload in mmwhere mm is the minutes you like the device to reload after and make your changes and if it didn't work as intended, the device would reload from the startup config. Just make sure to not copy the running config to the ...
