Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi,Configuration : CCME 3.1 or 3.2 on 2651XM (12.3.8T)PSTN--> call IP PHONE with CFA --> PSTN -external french phone 01XXXXXXXX)---- OK----PSTN--> call IP PHONE with CFA --> PSTN -GSM with 06XXXXXXXX) ---- fail-----In fact I don't receive from the GS...
Hi everybody,I need some help or ideas.This is my issue and I don't know how to solve it------------------------------------------------Topology :IP phones <--> CCM 3.3.3 <--> IOS gateway 12.3.1a <--PRI_E1--> PBX <--> traditional phones <--> PSTN----...
Do you know if it exists a command when an AIM card is on the slot 2 of a 2691 XM and the E1 module is on slot 0.Does it exist a command to tell the E1 card on slot 0 to use the DSP in slot 2. Irene
Does anybody have already successfully tested MOH on SRST mode ?SRSTV3.0 IOS 2610 XM 12.3.4T1I mean 2 IP phones on SRST mode IP phone 1000 calls ip phone 10011001 answers and put on hold the call and on 1000 I can heard a "bip" every 10s but not th...
Thanks for your quick answer Partha.This is the result of my tests :When working on SRTS mode, a call through the PSTN(which is a PBX interco (T2) doesn't allow MOH to work (no beep too) but it's not a direct access to the PSTN...Between 2 Ip phones ...
This is my need :2 Cisco Router 1760 with VIC 2B-NT/TE (ISDN BRI). They need to be connected Back to Back using BRI interface to simulate the Provider and the user sideIrene
