Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi All,Is it possible to use a prefix list to remove a specific network from a summary advertisment that was received from a BGP peer?Example:I receive 192.168.0.0/22 from an EBGP peer. I want to filter out only 192.168.0.0/24 whilst still allowing 1...
Hi All,Does anybody know if there is a way to disable SNMP traps being sent for specific HSRP groups?In my scenario, I have a number of routers that have multiple HSRP groups defined. Two HSRP groups from each router are in a INIT state because the s...
Hi All,I was wondering if anyone can clarify if the NM-1FE2W or NM-2FE2W will work in the 2610XM?These two pages seems to contradict each other:http://www.cisco.com/en/US/products/hw/routers/ps259/products_relevant_interfaces_and_modules.htmlhttp://w...
Hi All,I did a little bit of re-configuring in my lab and came up with a problem with two NM cards.Both cards are labeled as NM-4A/S on the back panels. From cisco.com, both should work in my 3620's and 2651XM'sBoth cards work in the 3620, but one of...
Hi All,I am in the process of setting up a new Microsoft NLB web farm. I've only ever configured this before on a single switch so I'm looking for a sanity check on the setup for two switches.I have 2 web nodes, both running Microsoft NLB in multicas...
Hi Tom,I've never worked with these interface modules, but is it possible that you have to set a clock on one side of the back to back circuit? (In the real world, this clock would be provided by your mw cpe)A quick search turns up "atm clock interna...
Hi Jigar,If you view the connection manager "View" --> "Connection Manager". Create a Telnet/SSH session for all of your devices (only need to do this once) then save it.Right click on the Telnet/SSH folder and select "Connect All" You have to re-arr...
Hi Jigar,Putty Conection manager might help you here (http://puttycm.free.fr/cms/)You create a database of all your routers and then connect to the database - this opens a session to all of them. there's a command sender built into PuttyCM.Only for ...
