Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi,
There is no ping reply when pinging to the cluster IP for Windows Network load balancer from external network. Below command has been added to the L3 switch and internet router.
Ping from Local network, it is working fine. There is the reply fr...
I built a vpn tunnel to connect HQ network with branch office. The VOIP phone from branch office is connected to the phone system in HQ. The voice is clear but it will get disconnected occasionally. I did the continuously ping from branch office to J...
The port link aggregation is not working between Cisco switch and Juniper switch. Below is the configuration. Anything not right? Please advise. Many thanks.Cisco:interface FastEthernet0/21 switchport trunk encapsulation dot1q switchport mode trunk c...
I plugged the cable from L3 switch with vlan1 to L2 switch that segregated by vlan for the connection to firewall. The L3 switch is using vlan1 and L2 switchport is assigned by with vlan number 689. There is the message keep coming out from the conso...
Maybe VPN solution is not feasible. I am thinking to do it on the interface for 10 MB leased line connection and reserve 1 MB for Voice server. The ip phone is located at remote office. Is below configuration correct? ip access-list extended VOICE ...
Hi,Below is the output:sh lacp internal detail Flags: S - Device is requesting Slow LACPDUs F - Device is requesting Fast LACPDUs A - Device is in Active mode P - Device is in Passive mode Channel group 4Actor (internal) inf...
