Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
hello,We have a vendor that does monitoring for us. We have a site to site VPN tunnel with them using Cisco ASA 5515-x. In order to monitor remote locations for us, they want access to all of our 200+ site to site tunnels so they access those devices...
I need help. We are in the process of changing a large L2 network. Everything terminates into a single small FW. The IP range is 172.16.10.0/22 so the end of the port configured on the FW is 172.16.10.1/22. This is where everything terminates.
No...
Hello all,
I am sure this is simple, but i have not found the correct answer to this.
I have a cisco 3850 L3 switch with multiple vlans.
see Config:
interface GigabitEthernet0/0 vrf forwarding Mgmt-vrf no ip address negotiation auto!interface Gigab...
Hello,
we have 3 vlans which we use.
We have a l3 switch which does the routing for us.
I need to know how i can setup in my 3850 l3 switch a way to route one specific vlan to a different gateway.
L3 switch will be connecting to 2 different firewall...
Hello!We use out ASA fw as vpn appliance for our company. Users throughout the country can use the cisco vpn client utility to connect to our vpn and get access to internal websites using dns.Recently, quite a few users (15+) are not able to translat...
Not to complicate things here, but in the very near future, i will be doing an IP change for all the devices in the field (well the customer will change their ips of these devices). I was thinking that in this vlan3 right now its assigned 172.16.10.1...
The firewall is all set. I can ping from the fw to this L3 switch and to a lapotp (connected to one of the other ports on the L3 in same vlan). I can ping from laptop all the way up to FW and from the switch i can ping 8.8.8.8 so all the routes are s...
This is something i have not tried yet because our window was very small for troubleshooting. I will be trying this again next week since i have a small window. I will clear arp on my L3 and i will ask customer to clear arp on the netgear switch if p...
Port 4 for now. I did not include other ports in this config, but there are 6 ports total added to this vlan so customer can plug into any of these 6. but for not we only have port 4 we're working with.
I have attached a crude design of what the existing network looks like and the new proposed design. Like i said, i removed the existing old FW and introduced a cisco FW along with a new Cisco L3 switch and created vlans on that switch. The customer i...
