Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I was looking at the settings for the CML 2 VM, and under options it shows the OS version as CentOS 5 and earlier for 64 bit. However, the OS is actually CentOS Linux 8 (Core) as indicated in the Web UI. I changed the OS version in the VM and I'm g...
For the last 2 days I've been getting this error:The Product Instance was unable to renew license authorization due to a communication timeout. Digging a little deeper I get this:The last attempt to renew license authorization failed for the followin...
I have a fairly simple topology, an ext-conn device is attached to an unmanaged-switch, an iosv-0 device is also attached to the unmanaged switch and an xr9kv-0 device is attached to the iosv-0 device. I start the lab simulation and all the devices ...
I had CML running fine. I had configured 2 interfaces on the CML VM, one bridged and one NAT. The address that got assigned to the CML was from the NAT interface. I turned off this interface and rebooted so the CML would get it's address from the ...
I have 2 systems, one at 192.168.10.5 runs a dhcp server, one at 192.168.10.66 runs the CML ova and the UI. I create a topology under CML which consists of a ext-conn device, an un-managed switch, and iosv device and an iosvl2 device. All devices a...
I'm getting this error, but when I enter radius-server host xxx.xxx.xxx.xxx I get an error about invalid argument pointing at host. So how do I specify the radius host address? I'm running Cisco IOS Software, C3750E Software (C3750E-UNIVERSALK9-M)...
I get that message every time I import the CML 2 VM. I always go ahead and do it and modify the VM as opposed to making a clone. Don't know what effect the upgrade has on the CML 2 behavior. Paolo
I'm running VMware Workstation Pro 15.5.6, this is the current version. The way I changed the OS version is to go to settings->options and change the OS listed under version. When I import the VM into Workstation Pro there is a check box to upgrad...
One way to eliminate the problem is to do the following on the CML VM sudo systemctl restart virl2.target This eliminated the 502 error for me and allowed me to de-register the license and re-deploy. Paolo
It's CML Personal. The system is a Dell laptop with 16 G memory and 4 cores (i7-4500U) running Fedora 30, with 8 GB allocated to CML-P. It doesn't always happen, but when it does it always stays that way until I redeploy CML-P. Paolo
