Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I have just upgraded some 2621 routers to IOS 12.2.16a and have noticed that the interfaces are always UP. This causes routing problems. Show Int fa0/0 says "keepalive not set". When I set keepalve manually it tells me that 10sec is the default. If ...
Netflow uses flows. This usually requires data from switching cache which means that it comes in one interface and leaves via another. You may have traffic which PS sees but which is not actually switched through router and does not appear in netflow...
Have you tried exporting the data from a Loopback address? This has the advantage of data still being sent even if an interface may be down (alternate routing being available).
Zaldy,You should have the two buildings on seperate lans, have the routers join these two lans using the wireless connection. The dhcp servers are on this local lan and then you do not need IP helper, unless you plan to use the other building dhcp se...
FEIP cards only supported one full duplex port or two half duplex ports (speeds were onl 100). When you configure two ports at FULL DUPLEXX you start to get problems.FEIP2 cards support FULL DUPLEX on both Ports.Scott
