Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello everyone,I have a question .My ASA 5515 is placed in a full meshed MPLS network.This ASA which has the IP address of the MLS router as default route has several vlan configured. Soon an Internet connection will be installed to which only one of...
Hello everyoneattached the logs of the non-negotiation of the l2l tunnel.the two peers are on two ASAs on different contextsIf I move one of the two tunnels on the main context, the tunnel is negotiated.Can you help me?
Thanks in advance
Daniele
RADIUS configuration seems not enough, this configuration work fine for SSH but with ASDM there are some problem, a lot of continuosly push were prompted from DUO on the DUO APP ... so doesn't work
the DUO solution for MFA work fine for SSH access but with ASDM there are some issues, during authentication we are continuosly prompted for a lot of push, this happen continuosly while ASDM application were loaded, anyone other got this same behavio...
I solved the problemthe subnet I used as peer had acl on the router only for a / 27 while I was using the IP included in a / 26.The problem is that the carrier on routers before my ASAs of our MPLS did not extend the acl to this subnet too.I changed ...
Thanks for the quick reply.I enclose the configurations of both ASAs.both configurations are of the single context where the L2L tunnel is configured.Thank you so much again.
