About pflavio

pflavio · 08-03-2006

One end of the connection is a 6500 layer 3 switch; the fastethernet interface is hard coded for 100M/Full. The other end is a fastethernet 3560 switch. When I set the interace in the 3560 switch to 100M/full, I loose connevtivity to the 3650 switch...

pflavio · 11-26-2006

Hi Jackson,We had a similar issue with the TCAM table exhaustion.This issue created some of the interfaces to do software switching which in turn caused high CPU. Here is what Cisco engineers recommended:BDD (Binary Decision Diagrams)algorithm did no...

pflavio · 08-04-2006

Hi,Bad cabling is what we suspected at the beginning. Cables were replaced but made no difference. Now we having the same issue with multiple 3560 switches in different locations.Thank you,Flavio

pflavio · 08-04-2006

Hi,That is exactly what happens.When I hard code both sides of the link (switches) to 100M/Full, I loose connectivity to the switch. Do you think is best to leave it in auto negotiate?Do you know if there is a documented defect (bug) regarding this i...

Member Since	‎06-24-2005 11:33 AM
Date Last Visited	‎09-05-2018 12:26 AM
Posts	4

User Statistics

User Activity

Question: 3560 switch - Hard coding fastethernet interfaces for 100M/Full

Re: TCAM error

Re: Question: 3560 switch - Hard coding fastethernet interfaces

Re: Question: 3560 switch - Hard coding fastethernet interfaces