Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
hello everyone,see i have two new 1841 routers with wic-2t and wic-1t.These routers are connected via vsat link.ports of vsat modem are rs-232.I am using smart serial rs-232 dte cable at one end(router with wic-2t card) and normal rs-232 dte cable at...
hello everyone,What we normally configure ip addresses of serial interface is by putting both addresses in one network and using /30 as there subnet mask.I want to know if we dont configure ip address and use ip unnumbered (suppose) ethernet0,then ho...
hello everyone,I have two 4507R switches and nine 2950 switches,each 2950 having two fiber ports of which one port is terminated into one 4507R switch and second into another switch.Again we have configured vlans (1 by default,2,3,4).Now the problem ...
hi everyone,I have 506e pix with 192.168.1.1 as its inside ip address and i have one public ip address configured on outside port.I have no public ip address pool but i am overloading its outside port and eveything is working fine.I have one more loc...
Loobback Interface is configured just for management sake and for this u have to configure ip address which should be like 192.168.100.100 255.255.255.255.As this interface never go down so,it is used for accessing routers.
hello,I have router with one ethernet interface and i want to configuring natting,can u give me some sample configuration.See i have got one public address and this very ip address,i want to use for all private ip address(patting/overload)Arun Kachro...
Thanks for replying so soon,but as u know 2950 switch only support dot.iq encapsulation,so every 2950 switch connecting with 4507R switch is using the same encapsulation.As i was going through cisco.com,it is written that isl only supports hsrp.can u...
yes,see vlan1 is by default and every port is intial in valn1.Second by configuring ip address of vlan1 as 10.10.12.1/24 should have no problem for pc,s to communicate with router.But u cannot access yr switch from yr pc,s.Arun Kachroo
