Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Here's the overview:We have a customer who will be accessing managed services located in our data center. I have a 1941 router (with a 4-port ESW) at the customer site and a 3750 stack in our data center that has the managed resources attached. The...
I have several NAMs collecting Netflow data from various devices but I really do not like the built-in reporting functionality. Does anybody know if it's possible to export the collected Netflow data from the NAMs into another device like ntop, Ori...
I've been waiting for CSM 3.1 since it's supposed to support IPS 6.x but the download section doesn't show 3.1 as an option. There is a patch for 3.1 but not the app itself. It sure sounds like it was available as there are people talking about it ...
Can't find this on CCO one way or the other but I need to pull an NM-4T out of a production 3660 and would prefer to do it while the router is powered up.Thanks,Rik
Well, I don't have a compelling reason to use L3 at this point. Originally the plan was to use VRF over L3 links for path isolation but the migration path created by changing the server addresses was ugly so I decided to go the L2 way after the rout...
You can also try to send that one back in via RMA and get a card with an older version of code. I've done that in reverse (had older and needed newer) and while they tell you they can't promise a specific version of firmware on the card they always ...
I think you better re-read the requirements for Rapid-PVST+. 3500XL series switches don't support it so connected devices running Rapid-PVST+ will fall back to PVST mode anyway. In other words the upgrade will do nothing for you so long as you have...
I've run IGPs of all flavors on 12.2(44) code with no issues. Have you tried to reboot the switch? How about just a "clear ip route *" command?You didn't make it clear that you are running RIP or some other IGP so please clarify that point.
Well, by the book you are correct. However an LC GBIC/SFP will light up MMF for short distances.If you compare the two types of fiber (MMF vs SMF) you will find the key difference is the number of "modes". Simply put, a mode is a light path. Since...
