Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Platform: Cisco 6500Anyone run across creeping alignment errors across ports on the blade?This symptom is coupled with slow ping response over those ports.
Anyone run across this problem? This problem occurs on a Catalyst 5505.When portfast is enabled, ports connected to Win2000 workstations go into errDisabled state upon power up. Ports are re-enabled and work fine until workstation is power cycled, at...
You've probably already checked, but check your subnet mask and VLAN settings for the fast ethernet ports on both sides.Is the connected port on the management VLAN?Maybe you could cut and paste some configurations, since it is unlikely to be a hardw...
In this case, I suspect bad NIC cards. However, the desktop support people disagree and keep pointing at the switch. I'd like to verify the NICs but without desktop support, I cannot proceed. At this point, we've downgraded to 4.4.1, since they don't...
Turns out that Cisco SW 4.5(13a) has a feature that errdisables ports based on collisions detected. This feature wasn't present before and turned out to be the culprit. That and the fact that there were many collisions occurring when the PC boots up ...
Moreover, is there a way to monitor the amount of throughput that a particular blade is seeing? Is there a limit to the amount of traffic one blade can handle?
