About l-harvey

l-harvey · 09-19-2004

I have connected a 6513 to a 5513, no problems. But when I enable HSRP between the RSM and the MSFC the I have issues with the Vlans with bridge-group 1 set up. ie,RSM 5513 interface Vlan1 description Management and Trunking ip address 10.1.1.1 255.2...

l-harvey · 10-21-2003

I have dual 6513's(set-up for resilience) at my core. At this time I route IP,IPX and bridge( the OSLAN protocol, there is only one bridge-group, on my network(for an ICL mainframe)). I wish to connect a link from my Aggregation routers (3640s) to ea...

l-harvey · 09-20-2004

My CCo will not access these short cuts.But the MSFC 2 will only support 16 standby groups I have over 35 Vlans.

l-harvey · 09-20-2004

The MSFC on the 6513 will only support maximum of 16 standby groups I have over 35 Vlans.I have noticed that the bridge 1 protocol on the 5513 is set to ieee and the 6513 is set to vlan-bridge due to the 6513 not supporting ieee I will try the next d...

l-harvey · 09-19-2004

Sorry the reason it's in shutdown is because it flaps.I have more than these two vlans. The config was an example. I can only have one vlan with Bridging enables on both devices, as soon as I add a second vlan with bridging flapping starts. This seem...

Member Since	‎06-23-2003 11:52 PM
Date Last Visited	‎08-18-2017 03:50 AM
Posts	5

User Statistics

User Activity

HSRP issues with Bridging

load-balance bridged protocols between 3600 & dual-6500s

Re: HSRP issues with Bridging

Re: HSRP issues with Bridging

Re: HSRP issues with Bridging