Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
The devices have been successfully added to Prime, but their data is not appearing on the main dashboard. However, under Monitoring → Network Devices, if we select any device its CPU utilization memory utilization ports VLANs IP addresses and other ...
We have installed Prime on our system and are trying to add our controller to Prime for SNMP trap monitoring. However, Prime is showing a Ping Failed error when we attempt to add the controller.The controller is able to successfully ping the Prime se...
we have two Cisco Access Points. One has successfully joined the controller, but the other is not joining. Both access points are connected to switch ports with the same configuration. we have also factory reset the AP, but it is still not joining th...
Dear,we have facing some issues related Wifi ssid we have two ssid configured in our controller wifi-guest(vlan1008) or wifi-User(vlan1009), but still showing Wifi-guest & proper internet working. so guide about second ssid.Regards,Muhammad Sufiyan
AP 140ac not showing SSID after zero day configuration,Now I’m trying to configure it permanently through the CLI, but as soon as it powers on, it boots and stops at a username and password prompt. After a short time it automatically reboots, and aft...
controller default Gateway is 172.16.10.1 and controller gateway is 10.10.200.1.firewall is running on different IP all network devices send data to core switch and switch send to firewall.
Prime is running on ESXI and IP is 10.10.200.221 and controller IP is 172.16.10.2.WLC able to reach Prime Infra, and is Prime Infra not able to reach WLC? >> yesIs any other device able to ping WLC IP address? yes all of the network devices ping WLC ...
