Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi:I am having problem with our router which have dual mpls link.The issue is that the primary mpls link is having bgp flapping issue while the secondary mpls link is not. We are using same standard bgp config accross the board. We have tried changin...
Hi,Can anyone help me validate this cause of this log below.I am trying to install a backup ipsec tunnel using dialer and i have been having this issue. Basically, the dialer interface config i used is the same with other sites, the only difference w...
Hi Vinayak:Good dayWe have N7018/7010 and N5K/N2KCan you guide me on where i can find troubleshooting guide for these platforms?Thanks in advanceRegards,Juls
Here is the configPlease note that we have replaced the router/move the link from built-in g0/1 to hwic-1fe, replace hwic-1fe. Tried speed auto/duplex autoBut when the local loop provide sent us their test router using the same bgp config/ip address ...
below is the out of bgp debug:bgp eventsbgp keepalivebgp updatesalso, i replaced the ip address of primary mpls to x.x.x.x and secondary mpls to y.y.y.yDec 29 00:41:35.474: BGP(4): Import timer expired. Walking from 1 to 1Dec 29 00:41:42.614: BGP: Y....
what i was looking for is more on network management and monitoringi was tasked to develop a methodology on network capacity planningand i want to know where should i start. the document outline and its detail. what are the variable that i should gat...
