I have a customer using a 100 Mbps Ethernet circuit and I need a router that can handle that type of throughput. Is it possible to give me the algorithm you guys use to figure this out with concurrent services of Voice, NAT, Encryption?
You must add a route to your Huwawi router stating finding the 192.168.2.0 /24 gateway to use is the 192.168.1.10. You have to routers in place and both routers need to know about the other. I would use rip v2Cisco 2811router ripversion 2network 19...
Just from the sound of what you have wrote you may have set the new switch in VTP Mode Transparent. Which makes the neither synchronize or advertise its configuration