Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
To configure the EtherChannel across different modules, you must first put the ports in the same administrative group using the following command :set port channel port_list admin_group(check the note on following link)http://www.cisco.com/univercd/c...
Hi : config register 0x5 would, since bit 13 is unset,it disables Boot default Flash software if network boot fails (0x2000) 02 to 0F : Specifies a default filename for booting over the network; enables boot system commands that override the default ...
Hi :Look on the 'sh spant summ' and check # of spanning-tree instances you are running. For the sup1 max amount is 4000. If # is fairly high, then you might want to consider removing vlans from the trunk ports that are not necessary.Or you can start ...
The error message %PARSER-4-BADCFG: Unexpected end of configuration file.\n Explanation :A configuration has been read from the TFTP server or NVRAM, and the end of the file has beenencountered before the end statement. The configuration may be corr...
Hi Seetharaman :Supervisor Engine Synchronization may happen during two conditions :• Synchronizing the Run-Time Image with the Bootstring : This will re-name the image on standby supervisor engine with RTSYNC extention.• Synchronizing the Boot Image...
