Hi,I know to configure a HSRP, we need to have minimum of 2 number of Routers/L3 Switches. How many maximum number of Routers can participate in single HSRP Group?ThanxRaju
Hi,I have a Cisco Switch which is a VTP server where I create all Vlans. I want to propagate this Vlan info to non Cisco devices (Nortel). I have configured dot1q as Trunking protocol ports connecting between these two Switches . Do I need to configu...
Hi,I want to know if 3845 Router and 4506 Switch with following IOS ver support BGP protocol.Router: Version 12.4, c3845-advipservicesk9-mz.124-12b.binSwitch: Version 12.2, cat4000-i5s-mz.122-25.EWA9.binThanx
Hi,Can I configure a single physical port in the Switch to be part of more than one Vlan . If so, what is the command?. For example port number 2/5 want to be member of Vlan 2 and 3. Pls note that I don't want to configure a Trunk port.ThanksRaju
Hi,Is it possible to configure both the nodes in HSRP as standby mode ?. It's a requirement for one of my client for testing purpose.Appreciated for your quick reply.RgdsRaju
Goutam,Check in 2960G side if you can able to see already existing Vlans created in 3750G .This will ensure that etherchannel is working between 2 switches and If you can't see any Vlan's in 2960G side, check ether channel config between 2 switches ...
Thanks for your reply. I know VTP is Cisco Prorietary protocol and I guess we can propagate to noncisco devices provided dot1 trunking is configured and one more parameter also has to match like Vlan tagging on both the sides should be same.
Thanks for your reply. I think we can make both the nodes as active (for testing purpose only, not in production environ). In that case, we should be make both the nodes as standby mode also.Rgds.
