Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
HiC9500 and C9300 running 17.12.5I have a working port-channel between the 2 switches with 1 active interface.When i add and enable a second interface the channel goes down and shortly after up, but then i have extremly high packet loss and loose man...
Hi,
I have a fiber connection from my ISP which terminates in a Cisco 897 VAMW. It has been running fine for several month, but recently we started getting very high packet loss (60%) when traffic hits 20Mbps.
Our ISP checked the fiber and it was wit...
Hi,I have installed a new 2960 plus with a original cisco sfp module connected to a 2960S, also with a new cisco sfp, as a trunk.Curently they are connected with a 2 mtr. fiber cable.The 2960S keeps logging this information:Rx power low warning; Oper...
enable udld on the int two1/0/30 and twe2/0/5 on Po33 did not show any uni links when i have the twe1/0/30 interface enabled.Total number of bidirectional entries displayed: 2TH-DK-MID2-DIST-01#sh udld neighborsPort Device Name Device ID Port ID Neig...
sh int po3Port-channel3 is up, line protocol is up (connected)Hardware is EtherChannel, address is 20db.ea50.9db1 (bia 20db.ea50.9db1)Description: UPLINKSMTU 1500 bytes, BW 10000000 Kbit/sec, DLY 10 usec,reliability 255/255, txload 1/255, rxload 1/25...
