Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I have a 5505 that currently has inside/outside interfaces and everything is working just fine. I am trying to create a DMZ that will essentially be just for vendors/guests. the DMZ will have full access to the outside (Internet) but no access to the...
OK. I am trying to set up a hub/spoke DMVPN to use the Loopback 0 as the tunnel sourec on the spokes. Right now I have about 150 spokes all using the F0/0 interface, but since that CAN be duplicated (by a home office such as a linksys giving out 192....
Pardon the picture, I don't always have access to visio. We have a home office and DR site connected via two 10Gb links. Those are port channeled on VSS pairs on each side. We are trying to connect fibre channel - or FCoE - between the two sites, whi...
Well, I've been working on this off and on for a few months (yikes) now, and we are still using local authentication for UCS rather than tacacs. I am attaching a few screenshots of how things are set up that I believe encomasses everything, but am mo...
It is amazing what one can do when ones questions go unanswered The WLCs connect directly to the 6509 in question, so I went into each of the physical Gb ports and addedmls qos vlan-basedto each of them, and it now polices properly
Jen, I can ping from local-mgmt. There is an admin role and a aaa role on the UCS.Michael, that command, when substituted for my values, gives me an error authenticating to server.
Alright!!! I renumbered the management ports of A/B to be in the same subnet as the local block. However, that leads me to wonder: Does every server on the UCS chassis have to be in that same subnet? E.G. if we have a financial vlan of 7 and a voice...
Hmmm...so far I am not trying to ping anything inside the UCS environment, so I think that invalidates the premise of your second question. when you say "same subnet as the addresses assigned to the Fabric Interconnects" do you mean the management IP...
