Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I am getting errors that state the following on WCS:"Access point 'APNAME' associated with controller 'CONTROLLER NAME' draws low power from Ethernet. Failure reason: 'The AP draws 15.4 watts from Ethernet'."I am using the 1250 series access points i...
This is probably a very silly question, but I am at a loss. Is the configuration information for each of the access points that has joined a wireless lan controller stored somewhere specifically in the configuration screens? I enabled the power i...
