Hello,I'm trying to enable SNMPv3 on my Nexuss 5548.  On my 2960 and 4900, I was able to use the commands below and snmpv3 works great.  How can I duplicate the configuration on my Nexuss 5548 so that it matches the config on my 2960.  It does not ap...

Attached is a config of my 4900M layer 3 router.  It has several vlans configured and I'm advertising the vlans through EIGRP.  Device plugged into a port configured on vlan 200.  The device IP is 10.234.252.10.I can ping 10.234.252.10 from the 4900,...

Hello,I have a network that has 3 subnets (10.234.240.0/24; 10.234.241.0/24; 10.234.242.0/24).  Within each of these networks I have several servers.  For purporse of example, all assign the following IP addresses:       Server 1, 10.234.240.10     S...

Below is my config of a Nexsus 5548 10 GB switch.  It's configured in a single Vlan (202) and uplinked to the same vlan on an Access port (Ethernet 1/1) to a Layer 3 switch.  I've crated an IP interface for VLAn 202 on the Nexsus and assigne 10.234.2...

Hello,I'm configuring my first Nexsus 5548 10 GB switch.  The config is very basic, it's a standalone switch that resides on 1 subnet, in vlan 202.  The subnet is 10.234.250.0/ 255.255.255.192.I created VLAN 202 on the switch and assigned IP address ...