Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
config-register on Cat6509(sup720, Native IOS)[config-register RP] Sup720-6509#sh ver........Configuration register is 0x2102[config-register SP]Sup720-6509#remote command switch sh ver........Configuration register is 0x101If Cat6500 is rebooting, w...
Hi all. We have serius problem.it auto reboots itself randomly, and at this moment we haven't find the cause. this is crashinfo file...Using sup-bootflash:crashinfo_20070619-121155.Writing crashinfo to bootflash:crashinfo_20070619-1211550 Error:3Jun ...
Below is log message(cat3550)-------------------------------------------Cat3550#wrBuilding configuration...% Warning: Saving this config to nvram may corrupt any network management or security files stored at the end of nvram.Continue? [no]:% Configu...
We have a Cat4500switch(Sup-IV).When support ipv6-hardware switching..According to "cisco ipv6 solutions calendar"(last year docoment), it tell "HW FW in late CY05"thanks.
thanks for your reply...but...problem is mutlicast in IPv612.2(15) support ipv6.but.. not support IPv6 multicast...Our problem is not IPv6.7500Router IOS not support (IPv6-Mutlicast)..T.Tthanks for reading..bye
7513router all cef switching..use..sh conf...boot system disk0:rsp-isv-mz.121-20.binboot system disk0:rsp-jsv-mz.122-15.T5.binenable secret xxxx...ip cef distributed....7513router#sh ip intGigabitEthernet3/0/0 is up, line protocol is up Directed bro...
I can't check the output of show alignment..T.T7513router#sh alignmentNo alignment data has been recorded.No spurious memory references have been recorded.7513router#
