Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi,I'm trying to implement IP SLA on router which should check internet connectivity via ISA server, which is proxy. I tried this two configurations:!ip sla 10 http raw http://www.cisco.com source-ip 192.168.5.1 version 1.1 proxy http://192.168.255.2...
Hi,I am trying to accomplish next scenario:a) ASA is configured as local CA and it issues certificates for Anyconnect VPN clients - OKb) when VPN user install issued certificate in its Personal folder that certificate should be used for authenticatio...
Hi,I am just curious how does SLA monitor on ASA work. As I understood and tested on GNS3, when configure SLA Monitor you have to specify outgoing interface and by that you are forcing packets (e.g. ICMP) out through specified interface (something th...
Referencing to this doc:https://supportforums.cisco.com/docs/DOC-16177which was very helpful, I noticed that I'm getting this error message:%SW_MATM-4-MACFLAP_NOTIF: Host d067.e5cc.2e49 in vlan 1 is flapping between port Po11 and port Po12I have Dell...
Hi,
I'm trying to do similar EEM applet on 6800, IOS 15.1(2)SY1. I believe append is not supported, so I've done it like this:
event manager applet OSPF_FLAPS authorization bypass
event syslog pattern "FULL to DOWN, Neighbor Down: Dead timer expir...
Hi,I've just done the version that works. The problem was also the fact that only authenticated users could pass ISA to reach certain web site. After adding access rule which allows unauthenticated users just for this SLA purpose I get working scenar...
I've managed to resolve this issue succesfully. Something was wrong with certificate mapping.The strange thing now is when the VPN user disconnects SSL session in ASA's log I can see some strange IP address (not the one the user establishes the VPN c...
If i have specific route to some public IP then after switching to second ISP traffic towards that IP will still go on broken internet link, right?Regarding ping outside1 x.x.x.x I do not have a route in the routing table.
Today I started scenario again and it didn't show the flapping message and I even didn't configure mst instances to be same on both switches. However, just in case I will configure instances to be equal on both sides. Thanks.
