Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello guys,I'm planning to buy a ASA 5505. However I'm not sure that I can setup this device with 3 inyerface outside, inside, and DMZ. Does it allow to have 3 ports used for these purposes or only two ports for outside and inside ?Kind of confused. ...
I have one 3560 L3 Switch and trying to configure 802.1x. All configuration seems fine but I think I'm missing something on the server side or Client. Which configurations do i need to do on server side ? thanks for your help
I'm planning to get Cisco Catalyst 4500 Series Supervisor Engine II-Plus for cisco 4503 chasis. The main concern for getting this is implementing the VMPS as server.However this supervisor engine comes with Cisco IOS and Cisco IOS does not support V...
What will cause to a Supervisor engine to become faulty . In my Cat 5505 everything is working ok but when I issue sh module I'll get thisMod Slot Ports Module-Type Model Sub Status--- ---- ----- ------------------------- ...
What kind of router you are working with.Because it seems like you have 10mbps interfaces and there is no way you can do intervlan routing on 10 mbps interfaces.min speed is 100 mbps...
1. create your poolip nat pool netmask 2. create access-list taht will allow your private address to be nat'ed access-list 1 permit 192.168.1.0 0.0.0.2553. do static translation if any neededip nat inside source static 4.inform your interfacesint ...
