Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
HI, Can you please share a couple of output:show ether-channel summaryshow moduleshow version Also can you let me know which port-channel you are talking about and which line-card is the port-channel is?Is it the VSL link you are concerned and if yes...
Hi Lucas,Even if the switch is in L2 mode (w/o L3 daughter card) you can create some SVI or a loopback interface and assign IP address to it.Refer to this configuration example guide:http://www.cisco.com/c/en/us/support/docs/switches/nexus-5000-serie...
Hi, Can you please share the output of the below commands: 1. show version2. show switch internal flash3. show system internal dir /var/sysmgr/workRegards,Seemab
Hi Adrian, I checked the BUG and for 22XX Fex the Jumbo Frame configuration has to be done globally. This is part of the design for these series of Fex.So i would suggest to enable Jumbo frames globally and see if the issue gets resolved. Else you ca...
Hi Rob, For the C2248TP-E Fex the Minimum NX-OS requirement Cisco NX-OS Software Release 5.1(3)N(1)1 (Cisco Nexus 5000 Series). It wont come up any version below this.Sorry to say you will have to upgrade the NX-OS version on the N5K.Regards, Seemab
