vss 1440 Link aggregation in the port-channel

[Richard Lucht]

We are setting up a vss 1440 with 2 6509.  I have 2 supervisor blades per chassis.  I have 4 tengig ports on each switch in each port channel.  we followed the configuration guide from CISCO.  In a SH IP INT BR we only see one port on each switch in the port-channel as up.  We want all ports up, after doing some research on the web I am still stuck.  Does anyone have any ideas?

[seemakha]

HI,

Can you please share a couple of output:

show ether-channel summary

show module

show version

Also can you let me know which port-channel you are talking about and which line-card is the port-channel is?

Is it the VSL link you are concerned and if yes on which module is the VSL link connected to?

Regards,

Seemab

[Richard Lucht]

Hi,

Thanks, we got it figured out. When we ordered the chassis they back ordered one sup720.  When we got it we did not notice that it was not a 10G-3CXL, it was a 10G-3C.  On the other chassis with the 2 correct blades we updated the IOS to the newest version on the active blade but not the standby.  For the most part it is up and running on 3 sup blades.