Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello Community, I'm struggling to get my CW9178I APs meshing on my 9800-L-F. I have followed a Configuration Guide from YouTube, but I am stuck at the part where i am supposed to classify the "AP Mode - Bridge" and "Role - Root/Mesh". I cannot find ...
Hello Cisco Community,I was hoping someone could help me figure out why my CW9178I's MIC is not being accepted by my 9800-L-F controller.All of my troubleshooting has lead me to believe that the AP cert if not being accepted due to being invalid/inac...
Hello community,I just spun up a Cisco Catalyst 9800-CL Wireless Controller 17.18.1 on ESXi in my home lab, and I have a brand new CW9178I out of the box. Once I finished setting up the controller I plugged the AP into my switch on a port that can se...
These are the three configuration guides I have been referring to:https://www.cisco.com/c/en/us/support/docs/wireless/catalyst-9800-series-wireless-controllers/215100-join-mesh-aps-to-catalyst-9800-wireless.html https://www.cisco.com/c/dam/en/us/td/d...
What is going on:From the U-Boot I am following this recovery method.https://www.cisco.com/c/en/us/support/docs/wireless/catalyst-9120axi-access-point/217537-repairing-c9120-c9115-access-points-from.htmlAfter resetting the AP, and logging in, I'm try...
Mark,I tried uploading 17.3.5a and 17.6.3. I still got an error after executing "install active" for both of these.The errors I got when I tried uploading 17.6.3 were different than the errors from 17.3.5a. I'm not sure what to make of them. I'm not ...
Rich,I started following that guide, but I ran into an error when executing the "install active" command.AI keeps pointing me toward the error being an issue with the "install repository state".I attached a picture of CLI session where I'm inputting ...
Hey Mark,I started following that guide, but I ran into an error when executing the "install active" command.AI keeps pointing me toward the error being an issue with the "install repository state".I attached a picture of CLI session where I'm inputt...
