Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello all, I'm installing a pair of 1572 aironets in bridge mode to connect a remote workshop to my network. Bridge only, no clients will connect. When adjusting the directional antennas, how do I see signal strength in real time to get the best conn...
How do you see the reliability, rxload and txload on a L3 VLAN (SVI)? If you #sh int it only shows that info for physical interfaces, not VLANS. On a 9k that is connected I'm seeing a saturated VLAN but I don't know what is happening on my 5k.
So I noticed a high rxload on a L3 VLAN and raised the bandwidth to help it and it worked but I'm not sure what is really happening.
I have decent number of nodes PXE booting on VLAN XXX, but doesn't seem like too much.
#sh int vlanXXX
reliability 2...
The CPU shows a normal low other than a spike when everything is rebooted, but doesn't look unusually high. As for the reporting, I feel like it actually is allocating more resources since the load is a fractional representation and 255/255 of 1g is ...
