cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
650
Views
0
Helpful
2
Replies

How to see RSSI on WLC? Trying to adjust directional antennas for aironet bridge mode.

mikenewcomb
Level 1
Level 1

Hello all, I'm installing a pair of 1572 aironets in bridge mode to connect a remote workshop to my network. Bridge only, no clients will connect. When adjusting the directional antennas, how do I see signal strength in real time to get the best connection?

 

TIA

2 Replies 2

if they are in "Root Bridge" & "Non Root Bridge" mode, then you can use "show dot11 association <mac_addr>" CLI output to verify RSSI/SNR

 

HTH

Rasika

*** Pls rate all useful responses ***

I tried that but it was not accepted on either AP or the WLC CLI. Maybe an different code or something?

Review Cisco Networking for a $25 gift card