I have some Symbol MC9000G wireless barcode scanning guns that are hanging. I am using Cisco ACS 3.23 build 11 with 1200 series AP's. The wireless Symbol Mc9000G guns authenticate via MAC and LEAP and WEP from ACS serverA consultant working on the p...

ok, I have been using the pix too much. I need an "in" ACL on the serial1 interface of a 1700 series router. here is what it looks like from top down:10.0.33.26|Router1s1-192.168.3.2||s1-192.168.3.1Router2|ftpserver192.168.2.18I am ftp'ing from 10.0....

Inside interface 10.11.112.254Outside interface 65.xx.211.254I have a outside Nat setup to allow rdp to an outside NAT of 65.xx.211.51 to 10.0.21.184Need to translate the incoming packet to an 10.11.112.x ip.used this as a blue printhttp://cisco.com/...

I haven't seen any notice that the Pix Device Manager version 3.0 has been moved into general deployment yet?