Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hiwe have 2 lines. packets are not going through primary link. I have configured EIGRP. it is working. but fail over is not working. I tried with static as belowstatic route for leased line is 172.20.103.0 255.255.255.0 172.20.255.65 ( have changed ...
Hican I ask what is difference bewteen hotstandby and coldstandby in supervisor module 1 Standby Supervisor RPR Standby cold 2 Active Supervisor RPR Active Thanks
HiI had a strange problem with 6513 switcheswe have two 6513 switches. I removed access-list100 and modified in 2nd switch no problem for me, but when I did that in first switch, it went down and I connected console cable and I copied from startup-c...
Hiwe have link problem between 2 buildings that is fibre module is keep flashing green and amber, so we changed fibre moudule patch leads. still problem is not resolved. so to ensure that problem is not with switch, we tried with other switch, we hav...
HiI think I found a answer. am not sure "An outbound access list applies the filter conditions after the routing table lookup". (I found this in cisco website) still not convinced with this answer. because the access-list which I have pasted befo...
This access-list is ment only for wirless ineternet connection. I agree with you it subnet which is in access-list will not work since I gave no access-list, ut entire switch went down. am not able to access other vlan example 172.25.140.0,172.25.6.0...
